Pressure Washer Pull Cord Will Not Start

When a pressure washer pull cord snaps on a job it is a real pain.

Pressure washer pull cord will not start. Honda power washer when you shut down your presure washer the pump makes pressure before y. Over time some of the ingredients in the fuel may evapo rate leaving behind a thicker stickier substance. This sticky fuel can clog up the carburetor and prevent the engine from starting. If the starter rope won t budge when you try to pull it the engine may be locked up or the recoil starter may have failed.

No ned to panic this short video by paul crosbie at spinaclean will show you how to save. The end result is a carburetor that does not work and a pressure washer that does not start. Remove the spark plug and then pull the starter rope to see if the engine spins. A clogged carburetor is most commonly caused by leaving fuel in the pressure washer for a long period of time.

If the pressure washer does not start on that first pull you will be adding more and more with each pull. If you tipped the pressure washer on its side recently oil may have filled the cylinder preventing the engine from spinning. The carburetor might be clogged. The solution to this is to use a carburetor cleaning agent.

This pressure washer had a stuck pull rope. You will be able to feel this issue directly on your second pull as it will be just a little harder to pull. Flushing the carburetor out with a special cleaning agent should remove the residue and allow the power washer to start.